Everything you need to set up, connect, and operate your new Revolution Post Driver — organised into short, focused videos by Tony White. Use this page as your go-to reference whenever you need a refresher on any part of the machine.
How to reduce mast height to approximately 2.9–3 metres for transport on a high bed truck or trailer. Tony walks through the four-hole pin system that controls mast tilt angle, the technique for neutralising load in the angle ram before moving the pin, and safe use of the safety pin as a displacement pin during the adjustment. Key note: loctite must be replaced every time the keeper bolt is removed. Skid steer setups run in the far hole; tractor setups use the second hole in as primary.
What to expect when your Revolution Post Driver arrives, and how to correctly tie it down for transport. Tony covers the machine's stable mid-mount (triangular) footprint on delivery, the correct three- to four-strap load binder technique for securing to a truck or trailer bed, and a critical note about keeping hammer rope slack before disconnecting hydraulic supply.
